A DIN 5480 shaft and an ANSI B92.1 hub can have the same tooth count and a similar outside size. Before treating them as a pair, compare the working flanks, the root and tip clearances, and the limits on fit. Keep each drawing in its own system while you establish what it specifies.
Read the complete designation
DIN 5480 defines involute splines based on reference diameters. DIN 5480-1:2026-05 uses a 30° pressure angle and flank centering. A legacy drawing may cite a different edition, so record the one that governs the part in hand. Use the corresponding dimensional and inspection provisions when reconstructing its limits. DIN Media’s DIN 5480-1 listing.
ANSI B92.1 covers straight involute splines and includes spline pitches, element tolerances, and tooth thickness and space width requirements. For a drawing that calls up the inch system, keep the original pitch and fit designation with any metric conversions. Read the specified angle and the fit and root details from the actual callout and its governing edition. ANSI’s B92.1-1996 scope.
Build a comparison from both limit sets
| Compare | What to resolve |
|---|---|
| Pitch and angle | Convert dimensions in the same geometric plane and confirm the actual flank definition. |
| Major, minor and form diameters | Check the limiting shaft and hub sizes for tooth tip, root and form clearance. |
| Effective fit | Use the governing definitions of effective tooth thickness and space width, including the effects of permitted tooth deviations. |
| Engagement and inspection | Compare usable length, end relief and gage requirements in the assembled condition. |
A shaft that slides into one hub sample gives you information about that pair. For repeat supply, you also need to check the limit combinations. A small change in tooth thickness, lead or spacing can change the fit over the full engagement. Confirm whether the original design allows a sliding fit or expects a fixed connection under load. AGMA spline design and inspection guidance.
When only one drawing is available
Ask for the mating revision and the original acceptance method. If only a sample survives, have the drawing owner agree which features will be measured and what evidence will establish compatibility. Check the dimensions and gage limits in the licensed editions before releasing a change. If either interface changes, document the proposed pair as an engineering revision and define the fit and functional checks for sample approval.
Attach both drawings or identify which mating component is missing when requesting a quote. Include the required engagement and whether the hub moves in service. Request a spline interface review.



